Authors:
Aftab Ahmed Ansari, Ujjwal Kumar, Atif Jamal Siddaque, Anis Ansari
Impact on the Performance of Direct Compression Ignition Engine by Adding Nano-Particle in Biodiesel
Authors:
Amit, Sudhir Kumar
Poka-Yoke and Quality Control on Traub Machine for Kick Starter Driven Shaft
Authors:
Atif Jamal, Ujjwal Kumar, Aftab A. Ansari, Balwant Singh
Energy Audit of Boiler at Chandigarh Distillers and Bottlers Limited
Authors:
Kabir Gaurav, Sumeet Sharma, D. Gangacharyulu
An Experimental Measurement of Ignition Delay for Diesel Fuel Blends at Different Cylinder Pressures
Authors:
Md Nazeem Khan, Inayat Hussain
Modelling and Multi Response Optimization of WEDM Operation of EN 24 die Tool Steel using Designed Experiments
Authors:
Mukesh Kumar, Jatinder Kumar
Investigating the Effects of Wire Electric Discharge Machining Parameters on MRR and Surface Integrity in Machining of Tungsten Carbide Cobalt (WC-24%Co) Composite Material
Authors:
Pardeep Kumar, Pratish Rawat
Six Sigma Perceptions for Capacity Waste Management in Indian Manufacturing Sector
Authors:
Rajeev Rathi, Dinesh Khanduja, S.K.Sharma
Theoretical Investigation of Electronic Properties of Armchair Graphene Nanoribbon
Authors:
Ritin Jhamb, Deep Kamal, Kaur Randhawa, Aseem Sharma
Effect of Shroud gas Injection on Thermal and Fluid Behavior of RF Plasma Reactor used for Nanosynthesis of Alumina
Authors:
N.P. Gulhane, Shirke C. R., A.K.Tak, S. Ghorui
Result Paper on – “Design and Development of Real Time Trainable Industrial Robotic Arm”
Authors:
Shruti V Ramteke, Kanchan Dhote
Energy and Exergy Analyses of a new Solar Assisted Ejector Cooling and Power Cycle by using Refrigerants R141b, R600, R601 and R601a
Authors:
Surendra Kumar Agrawal, Rajesh Kumar
Energy and Exergy Analyses of a new Solar Assisted Cogeneration Cycle for Simultaneous Production of Power and Double Effect Cooling
Authors:
Surendra Kumar Agrawal, Rajesh Kumar
Performance Evaluation of Neat Vegetable Oils as Cutting Fluid during CNC Turning of Aluminium (AA1050)
Authors:
Ujjwal Kumar, Atif Jamal, Aftab A. Ahmed
Optimization of Machining Parameters in Rough Cut WEDM Operation of EN 18 Die Tool Steel using Response Surface Methodology
Authors:
Vishal Singh, Jatinder Kumar
